Maybe there was already somewhere similar image, but here is how could be the shaft loaded in water, with Tomba kit. Shaft should be filed on one side to be as on image, to allow water to pass under the O-ring while being inserted in muzzle.
Shaft should be inserted into the muzzle together with cone ring, O-ring and the slider. After that holding the slider in muzzle, preventing it from moving forward during pushing in the shaft, shaft should be pushed in to make contact with piston. From that moment loading can be proceeded as usual.
Tal vez ya existía la imagen en algún lugar similar, pero aquí es la forma en que podría ser el eje de carga en el agua, con el kit de Tomba. Eje debe ser presentada en un lado para ser tan en la imagen, para permitir que el agua pase por debajo de la junta tórica, mientras que se inserta en el hocico.
Eje debe introducirse en la boca del cañón junto con el anillo de cono, la junta tórica y el control deslizante. Después de que la celebración de la corredera en el hocico, evitando que se mueva hacia adelante durante el empuje en el eje, el eje debe ser empujado para hacer contacto con el pistón. A partir de ese momento, la carga puede ser desarrollado como de costumbre.